Interest Protocol

Proposal to adjust the interest rate curve’s parameters to reduce interest rate volatility.

Interest Protocol uses an interest rate curve to dynamically set the borrow and deposit rates as a function of the current reserve ratio (which equals USDC in reserve / USDi total supply). Governance has the power to adjust the parameters of the curve itself to change how each level of reserve ratio is mapped into the borrow rate and the deposit rate.

The current parameters were chosen by GFX Labs prior to launch. Based on our observations of the protocol’s operations for the past two months, we believe that the following parameter adjustments would reduce the volatility of interest rates and improve the usability of the protocol. The interest rate curve is a core component of the protocol and should be continuously improved and thoughtfully experimented with.

Variable	Current Value	New Value
s1	60%	65%
s2	40%	35%
r1	0.50%	0.50%
r2	10%	20%
r3	600%	300%

Desmos graph

Our rationale for these changes are as follows.

Longer s2-s1 The length of the target range of the reserve ratio, [s2,s1], will increase from 20% to 30%. This is to reduce the likelihood of the reserve ratio diverging from this target range, which results in sharp fluctuations of interest rates.

Lower s2 s2 will decrease from 40% to 35%. GFX Labs set a very conservative s2 at launch, and we believe that reducing the target floor of the reserve ratio to 35% does not pose a significant risk to the USDi peg. By lowering s2, the protocol enables higher utilization of capital that can lower the borrow rate and increase the deposit rate.

Higher r2 r2 will increase from 10% to 20%. We believe the equilibrium nominal borrow rate of USDi may often stay above 10%. This is because the protocol incentivizes borrowers, which decreases the real borrow rate. Raising r2 from 10% to 20% will allow rate discovery to happen across a wider range.

Lower r3 r3 will decrease from 600% to 300%. This will dampen the extreme rate volatility that has been observed when the reserve ratio drops slightly below s2. The maximum rate of 300% should still be punitive enough to drive the market back towards the target range whenever the reserve ratio is below the target floor of s2.